GPG S-Boot Cable

GPG S-Boot Cable - Supported Models and Features

• Repair Samsung I9300 Dead Boot
• Repair Samsung I9500 Dead Boot
• Repair Samsung N7100 Dead Boot

GPG S-Boot Cable - Repair Dead Boot Procedures

Repair Dead Boot Procedure for Samsung I9300

1. Insert SD card (I9500/I9300/N7100)
2. Turn off the phone (but do not turn off the power supply or leave a battery in)
3. Insert download clip
4. Wait 2-5 minutes (do not pull out the power supply)
5. After this process the phone automatically turns to DWL mode

Repair Dead Boot Procedure for Samsung N7100

1. Take off the phone screen (if not removed, the screen may get burned)
2. Take off Single PCB with regulated power supply
3. Insert SD card (I9500/I9300/N7100)
4. Insert download clip
5. Wait 5 minutes
6. Turn on download clip and run flashing platform
7. If the driver is recognized, load the file and flash the phone
8. After the end of the procedure put the screen back

Repair Dead Boot Procedure for Samsung I9500

1. Take off the phone screen (if not removed, the screen may get burned)
2. Take off Single PCB with regulated power supply
3. Insert SD card (I9500/I9300/N7100)
4. Insert download clip
5. Wait 5 minutes
6. Turn on download clip and run flashing platform
7. If the driver is recognized, load the file and flash the phone
8. After the end of the procedure put the screen back

Please Note: If the phone system hangs after DWL Mode, it may be the issue with Flash IC or other hardware